AA Battery Holder with JST PH Connector
This battery holder connects 2 AA batteries together in series for powering all kinds of projects. We spec'd these out because the box is fairly slim, and 2 AA's add up to about 3V for many low voltage electronics projects, plus it has a nifty on-off switch. Fits any standard AA battery. When using rechargeable NiMH the output voltage will range from about 2.7V with charged batteries to 1.8V at the end of life with a nominal voltage of 2.4V. When using alkalines, the output will range from 3.2V with new batteries to 2.2V at the end of life with a nominal voltage of about 3V. The polarity matches that of our 2-pin JST cable and Li-Ion/Poly batteries. Uses a genuine JST connector so it won't 'catch and tear' in JST connectors. This is a great update to the battery packs that come with micro:bit's because it has an on-off switch built in so you don't have to yank it out to turn off the power, and the AA batteries will last 3 to 5 times longer longer than AAA!
Note:
1. Small parts, please keep them away from children.
2. Please confirm whether it is the product you need before payment.
3. Please allow ±0-2cm difference due to manual measurement.(1 inch=2.54cm)
4. The flaws of the product in the picture are caused by reflections during shooting, the picture may not reflect the actual color of the item, subject to the actual product.
Please make sure you do not mind before you bid. Thank you!
Hot Tags: aa battery holder with jst ph connector, China aa battery holder with jst ph connector manufacturers, suppliers, factory, 40P 30cm Dupont Male To Male Jumper Wire Cable, XT90 Connector Plug 4mm Banana Plugs Adapter Cable , PH2 0 To 187 Terminal Block For TV Wire Harness, 40p 1.27mm Idc Flat Ribbon Cable, XT30 To XT60 Cable For 2S LiPo Battery Micro FPV Drone, 8Pin Female JST-XH Lipo Balance Wire
