admin@holly-electronic.cn    +86-570-2931442
enLanguage
Cont

Have any Questions?

+86-570-2931442

video

Jst Connector Cable For 3D Printer

jst connector cable for 3D Printer
Send Inquiry

Product Introduction

jst connector cable for 3D Printer

6-pin JST connector commonly used on the stepper motors found on 3D Printers on motor end

4-pin JST connector on the other (this connector is commonly found on 3D printer control boards, but differs from the also-popular Dupont connector).

2M length enables flexibility in mounting locations for control boards (outside of heated enclosures) and remote bowden extruders.

Please verify that the pinout of your driver/controller and motor match the pattern of these cables. Some configurations do not require the "crossover", in which case this cable should still work after simply removing 3 pins from one end of the connector by depressing the tab on the metal pin with a small pointed tool while carefully pulling the wire (one at a time), and then re-inserting the wires in the desired order (after bending the tab back out slightly so that the pins will lock into the connectors)


Note:

1. Small parts, please keep them away from children.

2. Please confirm whether it is the product you need before payment.

3. Please allow ±0-2cm difference due to manual measurement.(1 inch=2.54cm)

4. The flaws of the product in the picture are caused by reflections during shooting, the picture may not reflect the actual color of the item, subject to the actual product.

Please make sure you do not mind before you bid. Thank you!


Hot Tags: jst connector cable for 3d printer, China jst connector cable for 3d printer manufacturers, suppliers, factory, Jst Ph 2.0mm 3pin Connector Cable, JST SM 4Pin Male To Female 2 5mm Plug Cable, Ring Terminal Ground Cable, Molex 5264 2.5mm To 2.8x0.8 Faston Terminal Wire Harness, DuPont Dual Row 2 0mm Pitch Wiring Harness, Omron Switch Wiring Harness

Send Inquiry

(0/10)

clearall